40x40 Insulated Garage Pad Built for In-Floor Heat

This one started from scratch. Raw ground, a vision for a serious garage or shop space, and a lot of prep work standing between the two. That gap is exactly where we do our best work.

Before a single truck rolled in to pour, we set the insulated forms around the full perimeter. That foam edging isn't just a forming system - it's what keeps the heat in once in-floor radiant lines are running. Getting it plumb, level, and properly braced at this stage is what makes everything downstream easier. Cut corners here and you pay for it later.

Once the forms were set and the base was prepped, we laid down the vapor barrier and got the slab ready for concrete. The in-floor heat rough-in stubs are already poking through, waiting for the next trade. That's the kind of coordination that keeps a build moving on schedule. We think about what comes after us, not just what we're doing right now.

After the pour, our crew ran a power trowel across the entire surface to bring it to a smooth, tight finish. A slab that's going to see in-floor heat and heavy shop use needs that density at the surface - it's not just cosmetic. The finished pad is flat, clean, and ready for the next phase of the build.

If you're planning a shop, garage, or any kind of new slab - especially one with in-floor heat - the prep and forming stage is where the real decisions get made. We handle garage floor concrete and full garage and shop construction, so we can walk you through the whole process from ground-up.